Progress PK1040 Manual de usuario Pagina 1

user manualRefrigeratorPK1040

Technical data Dimension of the recess Height 1030 mm Width 560 mm Depth 550 mmRising Time 12 hThe technical information are situated in

Ventilation requirementsThe airflow behind the appliance must besufficient.min.200 cm2min.200 cm2Furniture alignmentImportant! Make sure that the kitc

b) Apply the adhesive sealing strip tothe appliance as shown in figure.2. Install the appliance in the niche.a) Push the appliance in the direction of

HaHbHcHd7. Install the part (Ha) on the inner side ofthe kitchen furniture.ca. 50 mmca. 50 mm21 mm90° 90° 21 mm8. Push the part (Hc) on th

Hb12. Press the part (Hd) on the part (Hb).HbHdDo a final check to make sure that:• All screws are tightened.• The sealing strip is attached tightly t

detailed information about recycling of thisproduct, please contact your local council,your household waste disposal service or theshop where you purc

212700401-00-21042009www.progress-hausgeraete.de

ContentsSafety information 2Operation 4First use 4Daily use 4Helpful hints and tips 6Care and cleaning 7What to do if… 8Technical

• It is dangerous to alter the specifications ormodify this product in any way. Any dam-age to the cord may cause a short-circuit,fire and/or electric

Service• Any electrical work required to do the serv-icing of the appliance should be carried outby a qualified electrician or competent per-son.• Thi

Important! In this condition, the refrigeratorcompartment temperature might drop below0°C. If this occurs reset the temperatureregulator to a warmer s

Helpful hints and tipsHints for energy saving• Do not open the door frequently or leave itopen longer than absolutely necessary.• If the ambient tempe

Care and cleaningCaution! Unplug the appliance beforecarrying out any maintenance operation.This appliance contains hydrocarbons inits cooling unit; m

Warning! Never use sharp metal toolsto scrape off frost from the evaporatoras you could damage it. Do not use amechanical device or any artificial mea

Problem Possible cause SolutionWater flows on theground.The melting water outlet does notflow in the evaporative tray abovethe compressor.Attach the m