Progress PHP5320X Manual de usuario descargar pdf (Pagina 33)

• If you have nonstick accessories, do not

clean them using an aggressive agents,

sharp edged objects or dishwasher. It

can destroy nonstick coating!

Cleaning the door gasket

• Regularly do a check of the door gasket.

The door gasket is around the frame of

the oven cavity. Do not use the appliance

if the door gasket is damaged. Contact

the Service Centre.

• To clean the door gasket refer to the

general information about the cleaning.

Pyrolytic cleaning

Warning! The appliance becomes very

hot. There is the risk of burns.

Important! Do not use Pyrolytic cleaning

function and the hob at the same time (if it

is installed with the appliance). It can cause

a damage to the appliance.

Before Pyrolytic cleaning:

1. Remove all removable parts and ex-

cess spillage from the appliance.

2. Remove the worst of the dirt manually.

3. Close the oven door correctly.

Using the Pyrolytic cleaning

1.

Press

again and again until the dis-

play shows

.

– The display shows PYRO 1 or PYRO

2.

– In 3 seconds the display shows a

message to remove all removable

parts from the appliance.

2.

While Duration

flashes, press or

to set the duration for the Pyrolytic

cleaning:

– 2:00 for a low degree of dirt

– 2:30 for a high degree of dirt.

3.

Press

to start the Pyrolytic cleaning.

The bars on the symbol

come on one by

one to show that the temperature in the ap-

pliance increases.

When the appliance is at the preset temper-

ature, the door locks and the display shows

.

When the Pyrolytic cleaning is completed,

the display shows the time of day. The oven

door is locked. When the appliance cools

down, an acoustic signal sounds and the

door unlocks.

To stop the pyrolytic cleaning at any

time, press

.

End time for Pyrolytic cleaning

You can set the end time for Pyrolytic

cleaning with the clock function End

.

1. Do again step 1, 2 and 3 from

above procedure.

2.

Press

.

3.

The display shows an arrow

and the symbol . The display

shows the time for the end of Pyro-

lytic cleaning.

4.

Press

or to adjust the time

for the end of the Pyrolytic clean-

ing.

Shelf Support Rails

Removing the shelf support rails

1. Pull the front of the shelf support rail

away from the side wall.

2. Pull the rear shelf support rail away

from the side wall and remove it.

Installing the shelf support rails

Install the shelf support rails in opposite se-

quence.

progress 33

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 79 80

Comentarios a estos manuales

Sin comentarios