Progress PAS6100E Manual de usuario descargar pdf (Pagina 31)

TROUBLESHOOTING

Problem Possible cause Remedy

You cannot activate the appli-

ance or operate it.

The appliance is not connected

to an electrical supply or it is

connected incorrectly.

Check if the appliance is cor-

rectly connected to the electri-

cal supply (refer to connection

diagram).

Activate the appliance again

and set the heat setting in less

than 10 seconds.

Problem with the house electri-

cal system.

Examine the fuse in the electri-

cal system of the house in the

fuse box. If the fuses blow

again and again, speak to

qualified electrician.

The residual heat indicator

does not come on.

The cooking zone is not hot

because it operated only for a

short time.

If the cooking zone operated

sufficiently long to be hot,

speak to the service centre.

If you tried the above solutions and cannot

repair the problem, speak to your dealer or

the customer service. Give the data from

the rating plate, three digit letter code for

the glass ceramic (it is in the corner of the

glass surface) and an error message that

comes on.

Make sure, you operated the appliance cor-

rectly. If not the servicing by a customer

service technician or dealer will not be free

of charge, also during the warranty period.

The instructions about the customer service

and conditions of guarantee are in the guar-

antee booklet.

INSTALLATION INSTRUCTIONS

Warning! Refer to "Safety information"

chapter.

Before the installation

Before the installation of the appliance, re-

cord the information below from the rating

plate. The rating plate is on the bottom of

the appliance casing.

• Model ...........................

• PNC .............................

• Serial number ....................

Built-in appliances

• Only use the built-in appliances after you

assemble the appliance into correct built-

in units and work surfaces that align to

the standards.

Connection cable

• Use the correct mains cable of type

H05BB-F Tmax 90°C (or higher) for a sin-

gle phase or two phase connection.

• Replace the damaged mains cable with a

special cable (type H05BB-F Tmax 90°C

or higher). Speak to your local Service

Centre.

progress 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

Comentarios a estos manuales

Sin comentarios